Pen Calibration
If your cursor pointer does not function well, you can
select the “Calibrate” function available in this system.
- From the “Control Panel” scroll down to locate the “Tablet PC Settings” icon.
- Click on the “Calibrate” tab.
This setting will enable you to adjust the screen orientation.
Use your pen to tap on the four corners that appears on the screen.
Top
Yes. Your Scribbler Tablet PC came with additional tips and a tip replacement tool. To use the tool, simply grasp the old point with the ring and pull out the old tip. Insert a new tip and apply slight pressure to set it in place.
Top
Battery Status
Windows 7 has an applet in the Control Panel that will display an icon in the Windows taskbar indicating when the computer is running on battery power or is attached to the AC adapter. This applet also displays a meter that indicates how much charge is remaining in the battery.
Battery Low Warning
When the battery is in low status, its LED indicator will blink continuously and you will hear beeping sound.
Battery Status
This function indicates the remaining power of your system if you are using the system on battery charge.
Top
Charging the Battery Pack
The installed battery pack charges automatically whenever the computer is connected to the AC adapter and an external power source.
The first time you use the battery, be sure to fully discharge the battery and recharge it until it is fully charged.
Preparing the Battery Pack for Use
Before using the battery pack for the first time, the Smart Battery IC within the battery pack should be calibrated in order to get accurate reporting of the remaining battery life status.
To calibrate the battery pack, follow the instructions below:
- Turn the computer off. Connect the AC adapter and let the battery fully recharge. When the battery charge LED turns from orange to green, the battery is fully charged.
- Turn On the computer and let the battery run down until the battery is low-low and you hear continuous warning beeps. The system will automatically enter the Suspend mode. You can now connect the AC adapter.
- The battery pack is now properly calibrated.
Note: - In general, using the battery until the low battery warning indicator appears and fully recharging the battery each time (full discharge/charge cycle) will ensure the accuracy of the battery status gauge.
Automatic Battery Pack Charging Function
You can automatically charge the battery pack by using the AC Adapter.
Note: - The charge time is almost two hours when the computer power is turned off.
Top
Adjusting the Volume
The volume can be adjusted using the selection provided by the Mobility Center. Use can scroll to the right direction to increase your system volume or scroll to the left direction to decrease the volume.
Top
Headset microphones are recommended for improved voice recognition.
Top
Use the soft cloth or similar soft fabric to wipe away dust and fingerprints. Dampen the cloth with water or computer-screen cleaner if necessary, but never spray anything directly on the surface. If liquid collects around the edges, wipe it up immediately.
Top
The Computer’s LED Button Controls
The computer provides you with special hot keys to execute all the major functions that you like to run on your computer.
Note: - Use finger tip to tap the icon  twice until an orange light will lit up all these four LED button. When all the LED buttons are lighten up, you can now use these buttons to execute some of the available function provided by this system.
(1) Rotation Screen/Window 7 Flip 3D LED Button
Use your fingertip to tap this LED button once to convert your screen display into landscape and portrait view.
Your screen display will start rotating at 90 degrees clockwise angle until you prefer what angle that most suited for you to view.
You can also use the “Rotate Screen” function on the Mobility Center to execute this application.
Note: - Tap this button for 1 second will let you execute the Vista 3D Flip application.
- From the “Control Panel” scroll down to locate the “Tablet PC Settings” icon.
- Click on the “Buttons” tab.
You can now change the control keys by clicking on the “Change” tab.
Top
Inserting and Removing the Battery Pack
1. Inserting the Battery Pack
Note: - Before inserting the battery, be sure the front side of the battery is facing the top side of the system as shown in the illustration.
- Turn over the computer and place it on a solid, flat surface.
- "1" Align the battery into the battery compartment.
- With the three edge aligning to the three slot on the battery compartment.
- "2" Push down the battery to completely attach into the compartment.
Removing the Battery Pack
- Slide the battery latch as shown in the illustration.
- "1" Lift up the battery from the compartment.
- "2" Push down the battery to completely attach into the compartment.
Top
Up to 4 GB, Base unit has 2 GB.
Top
Upgrading the System Memory
- Turn your computer to let the bottom panel facing you. Locate the RAM compartment which is shown on the illustration. Unlock the two screws that attached to it. Lift up and remove the RAM compartment door.
- Use your left and right thumb to unlock the two latches (shown in the illustration) to release the RAM. The RAM will be lifted once it is release in 15 degree angle.
- Pull out the RAM from its slot.
Top
You can upgrade the HDD up to 250 GB. Base Unit has 160 GB.
Upgrading Your Hard Disk Drive
Note: - We are not guarantee 100% of market items can be support at T22x models of Tablet PC.
Top
Press and hold the wireless radio button for three seconds.
(3) Wireless & Blue Tooth On/Off Switch: - Slide this latch to turn On/Off the wireless LAN & Blue Tooth.
Top
"ON" the wifi switch on tablet PC located at the left hand side top menu when scribbler is in landscape mode with light indicators facing top. Until one gets it “off” wifi will remain on.
Top
Yes. Press F11 during boot up to launch the system recovery menu.
Top
Click on the TouchKit icon on Desktop. Click on Settings Tab, go to Option, deselect the Enable Touch option, click on Apply and confirm the settings.
Top
SC4100 has built in camera, Digitizer & Touch screen, Intel Core 2Duo ULV processor, Windows 7 operating system, Bluetooth, Maximum 4GB external RAM, 250 GB Hard drive, Finger print Sensor and TPM security device.
Top
Rotation button is hiding underneath the glass penal out on right hand side top corner when the scribbler is held in landscape mode. Tapping the rotation sign button with a finger twice until an orange light will light up all these four LED buttons can activate this button. When all these LED buttons are lighten up, a single tap can be used to rotate the screen in four different dimensions.
Top
Yes, the screen is pressure sensitive.
Top
Yes, SC4100 is compatible with PPD95 and PPD130. Smart output tip O 5 and Input charging tip I 2 are compatible tips.
Top
4GB maximum, but Windows 7 operating system has a limitation so one can only use 3.24 GB. At this point of time, it is better to go with total 3GB RAM memory.
Top
SC4100 offers three power management plans through Windows 7 operating system. There is also option to create your own power plan. The battery life depends on the selected power plans.
- Power saver – most life time
- Balanced – Intermediate of both
- High performance – least time
Battery life can be increased with other factors for example decreasing the screen brightness, keeping the wireless on only when required, choosing when to turn off screen and hard drive etc.
Top
No, a Bluetooth or a USB keyboard can be used
Top
Scribbler SC4100 series will only support Window 7.
Top
SC4000
BIOS is manufactured by Phoenix Technologies Ltd.
Version: NAPA001.86C.0000.D.0712071648
SC4100
BIOS Vendor: Phoenix Technologies Ltd.
Version: NAPA0001.86C.0000.D.0912041712
Top
The processor speed is 1.5GHz and it is a Core 2 Duo L7400 processor with FSB of 667MHz
Top
Please visit the following page for the information and visit the product tour and the specification page:
http://www.scribblertabletpc.com/model/SC4100.aspx
Top
No, they are both completely different machines.
Top
Camera is fixed and is always facing the user because it is meant for video conferencing.
Top
Windows 7 Home premium operating system comprises the tablet pc functions.
Top
FSB stands for Front side bus and 677MHz is the FSB speed. It is a key component for overall system performance. The faster the front side bus speed is the faster is the overall performance of the system.
Top
Maximum VGA port output recommended is 1600*1200 at 60Hz and can go up to 1920*1440
Top
|